|
Post by outthere on Oct 23, 2014 9:34:50 GMT -8
I originally bought the RaspiConnect app and set it up, it worked fine. I then bought the Live Controls package, ArduinoConnect Package, and Debug Package. All 3 packages are checked in the settings tab and I do have a working "Debug Window". Where's the ArduinoConnect Page, and the Live Controls Page in demo mode. Do they exist in demo mode?
Edited: Actually, I found the LIVE Controls page, quite by accident. The .... at the bottom of the page works (sometimes). I don't know if it is too close to the tab bar at the bottom of the screen, but I keep on activating the "Panel Setup" and "Settings" tab instead of the next or previous page. I also tried an electronic stylus (Apex) that usually works well in tight places, it also doesn't respond. I still can't find the ArduinoConnect page. Is it a stand-alone app? , if so it never go downloaded.
Edited: OK So, I managed to find the System Select "wheel" for the Raspberry Pi/Arduino. I installed the RasPiServer software, and got communications to the app (number of users, ip address etc is all there). Is there supposed to be any debug data passed to the app at this stage, the window has no text in it! I changed Debug = True in Config.py and still nothing in the debug window. I did add the lines to /etc/rc.local as mentioned in the "Getting Started"and information goes to the logfile. Does this prevent the debug window from working?
Thanks in advance.
|
|
|
Post by SDL on Oct 31, 2014 14:43:05 GMT -8
Outthere, Sorry to have been so slow in responding. I've been on vacation! The Page control works (and this is an apple thing) by touching at the beginning or end of the control and just a little above. Yes, getting the Arduino connect option adds the Arduino protocol to the wheel. There is a standalone App for Arduino people, but you can use both with the Pi and Arduino with this inapp purchase. Look in the Wiki on www.milocreek.com/wiki and you will find all of this information. Third question: You aren't getting a response. That means you aren't connecting to the server. Go through the testing in the Getting Started section in the Wiki and make SURE you are talking to your Pi. Check your configuration very closely for spaces in the wrong place in the URL. I've seen that before. Debug = True on the server only affects the Server, not the app. Great to do that though during debugging. Best regards, BP
|
|
xsy
New Member
Posts: 2
|
Post by xsy on Jan 7, 2019 17:26:22 GMT -8
Hi, I purchase Raspiconnect app few months ago. I don't how to start connecting Raspiconnect to raspberry pi B+. Have some document to get?
|
|
|
Post by SDL on Jan 8, 2019 20:05:40 GMT -8
We will put up the documentation in the next few weeks. Has to moved to another server.
BP
|
|