Post by weatherpi on Nov 14, 2017 15:14:08 GMT -8
On the new Grove WeatherPi wiring list it doesn't seem to contain the wire needed to use the code to blink the SunAirPlus LED.
PiA+ GPIO/Pin 22: GPIO 25 TO SAP JP13/Pin8: EXTGP0 FOR GP0 on SunAir Board - Yellow LED display
SUNAIRLED = 25
# blink GPIO LED when it's run
GPIO.setup(SUNAIRLED, GPIO.OUT)
GPIO.output(SUNAIRLED, True)
time.sleep(0.2)
GPIO.output(SUNAIRLED, False)
Without that wire it just stays on and doesn't blink.
PiA+ GPIO/Pin 22: GPIO 25 TO SAP JP13/Pin8: EXTGP0 FOR GP0 on SunAir Board - Yellow LED display
SUNAIRLED = 25
# blink GPIO LED when it's run
GPIO.setup(SUNAIRLED, GPIO.OUT)
GPIO.output(SUNAIRLED, True)
time.sleep(0.2)
GPIO.output(SUNAIRLED, False)
Without that wire it just stays on and doesn't blink.
