Post by Powderjockey on Jun 18, 2019 11:39:59 GMT -8
Today I received my 3.7v 6600maH battery and plugged it into the suncontroller board, the JST2 female connector(top left) and then connected a solar panel to the lower left female connector. within seconds the board extremely hot to hold/touch and a bad smell. I unplugged the solar panel and the battery. While unplugging the battery, the wires came out of the male JST2 connector.
Did I do something wrong and is the board toast? The wires ends are fine and I just need to try and slide them back into the connector end.
Post by Powderjockey on Jul 15, 2019 18:35:28 GMT -8
When build this yesterday, all of the pieces printed out and painted. I go to pull out the solar panels out of the bubble wrap packing and one of the panels has the black wire hanging, swinging in the wind. One more small set back to getting my SkyWeather up and running.