juanc
Junior Member
Posts: 50
|
Post by juanc on Dec 2, 2019 10:31:09 GMT -8
My solar WXLink only has 3 Good CRC Recived for each 10 readings and for some reason, the bad readings (with zero values) are uploaded to my Weather Stem page: skyweather.weatherstem.com/vicente_mayor
So when I access my weather page I see that most of the time the temperature and other data are zero as seen in the picture:
After several minutes I get a "Good CRC Recived" and it is uploaded and displayed for a short time before displaying Zero data again for a long period of time.
My other complaints about Skyweather Stem are that even when the temperature is set to Celsius: - Wind speed and gusts are in MPH and should be in Kilometers Per Hour
- Barometric pressure is in Inches and should be in Millimeters
- Rain and Total Rain Accumulation are in Inches and should be in Millimeters
- Sea Level pressure is in Inches and should be Millimeters
- Temperatures in Celsius should only have ONE decimal place, not display: 30.425738512222ยบ
It should be very easy to fix these very annoying display errors.
Please make this happen.
|
|
|
Post by SDL on Dec 3, 2019 10:11:54 GMT -8
First of all, WeatherSTEM has a problem with dealing with caches on various browsers. Try a second browser and see if this problem still is there. You can also clear all the caches from your first browser and then go back to WeatherSTEM.
I've reported these issues to WeatherSTEM.
BP
|
|
juanc
Junior Member
Posts: 50
|
Post by juanc on Dec 4, 2019 5:24:51 GMT -8
First of all, WeatherSTEM has a problem with dealing with caches on various browsers. Try a second browser and see if this problem still is there. You can also clear all the caches from your first browser and then go back to WeatherSTEM. I've reported these issues to WeatherSTEM. BP BP,
I have cleared my caches and tried 2 other browsers, but the problem still persists.
juanc
|
|
|
Post by SDL on Dec 4, 2019 10:15:02 GMT -8
Good feedback. I'll present it to WeatherSTEM.
BP
|
|