|
Post by howard on Jan 3, 2020 1:01:56 GMT -8
Hi,
I've just got the OurWeather V2 kit and had had a couple of issues setting it up.
When I powered it up and connected to it via it's own internal access point the configure wifi page didn't have all the fields listed in the manual. If I remember correct it only had details to connect to my own wifi network. There were no options to set the station name, set the date/time or altitude.
Then after it rebooted and connected to my wifi I just can't get it to connect via the OurWeather page (http://www.switchdoc.com/OurWeatherPage.html). I've entered the IP address the device has connected on and then clicked the Get Current Weather button but it just sits there saying not connected. I can see the device registered on my wifi
Any assistance would be welcome
Regards
Howard
|
|
chet
New Member
Posts: 48
Raspberry Pi: Yes
Other Device: PC, ESP8622
|
Post by chet on Jan 3, 2020 5:07:18 GMT -8
|
|
|
Post by SDL on Jan 3, 2020 7:44:11 GMT -8
Another thing you can do is "ping" the board to see if it is there on your network:
Check your IP number again too!
ping 192.168.1.130
Make sure you use your IP number!
BP
|
|
|
Post by howard on Jan 3, 2020 12:23:51 GMT -8
Thanks all. I had a weird wifi setting on my Unifi access point. Reset it back to default and I can connect now
|
|
|
Post by SDL on Jan 3, 2020 13:06:50 GMT -8
And you are rocking! What is the weird wifi setting? To help others.
BP
|
|
|
Post by howard on Jan 3, 2020 23:30:53 GMT -8
Not too sure but i would imagine it was one of the advanced features. The factory reset fixed it though
|
|