|
|
Post by triggerfish on Jan 16, 2020 10:06:08 GMT -8
Hi,
I put the code into the conflocal file, registerd my system at weatherstem, but there is no data transferred. I can not see the upload in the logging and I did set the USEWEATHERSTEM to True...
Where to look further?
|
|
|
|
Post by SDL on Jan 16, 2020 13:50:14 GMT -8
Peter,
Look in your nohup.out file for the send and the response to WeatherSTEM. Copy it here. That will tell us what is going on.
# WeatherSTEM configuration
USEWEATHERSTEM = False
INTERVAL_CAM_PICS__SECONDS = 60
STATIONMAC = MACADDRESS
STATIONKEY="XXXXYYYY"
you have to set your station key too.
BP
|
|
|
|
Post by triggerfish on Jan 17, 2020 7:30:37 GMT -8
The only refference to STEM in the logging is
pi@IBADHOEV14:~/SDL_Pi_SkyWeather $ skyGrep UseWeatherStem
UseWeatherStem: Present
My config is:
# WeatherSTEM configuration
USEWEATHERSTEM = True
INTERVAL_CAM_PICS__SECONDS = 600
STATIONMAC = MACADDRESS
STATIONKEY="MyKeyHere"
STATIONHARDWARE=""
|
|
|
|
Post by triggerfish on Jan 18, 2020 13:21:34 GMT -8
Ahhhh, I dug through the code and I guess my problem is a disconnected camera... Since I had yet to decide on a sensible location for the camera, I left it out for now. But it seems the WeatherSTEM system is only triggered after taking a SkyPicture, which fails because of a missing camera... Will connect it when I get home and try again. Why does WeatherSTEM NEED the pictures?
|
|
|
|
Post by SDL on Jan 19, 2020 11:12:17 GMT -8
Oh, it is a current requirement of our partnership. John is talking to him about supporting OurWeather which does not have a camera so we would change SkyWeather too if agreed.
BP
|
|
|
|
Post by triggerfish on Jan 19, 2020 12:34:44 GMT -8
No problem, I just was not aware of the fact. Given the fact my setup would produce mainly pictures of my balcony  I left it out to start with. But I am about to connect it and see what happens. |
|
|
|
Post by triggerfish on Jan 19, 2020 13:33:13 GMT -8
OK, check... WeatherStem is showing my data, on a noc picture of the inside of my station |
|
I left it out to start with. But I am about to connect it and see what happens.