|
Post by swb on Jan 19, 2020 12:54:34 GMT -8
I have looked through your website but can not find any drawings or dimensional layouts (specifically the mounting holes sizes and locations) for any of the Skyweather boards (except the RaspPi3 and the PiWeather Board). These dimensions would be helpful since I want to layout and mount all of the SkyWeather boards on a removable panel in the weatherproof Bud box, instead of gluing them directly into the box as your instructions suggest. (I felt that panel-mounting will facilitate circuit assembly and connecting/unconnecting the grove connectors). I can, of course measure the boards' overall size, but the mounting hole measurements are rather difficult due to the small hole size. Could you provide the mounting hole sizes and locations for these boards (or tell me where to look on your website)?:
1. Grove Power Save Board 2. the 12C Grove Hub Board 3. the Thunder Board 4. The TSL2591 Breakout Board (has one Grove Connector on it)
|
|
|
Post by SDL on Jan 19, 2020 13:05:19 GMT -8
Well, we don't have that directly. We would have to go back to the layout and measure them there. We can do that, but it will take a while before we get to that. Sounds like we should provide this on the Product Sheets.
BTW, for our 3D prints, we have just been using a micrometer to measure that hole placement.
BP
|
|