|
Post by triggerfish on Jan 20, 2020 5:51:35 GMT -8
Since I rebuild my old GroveWeatherPi into a SkyWeather system, thing go down hill very fast WX does not come on, ThunderBoard seems gone, camera needs to be connectedfor weatherstem which is not a problem itself, but sncie I conneted and activated the cam, SkyWeather does not start, but hangs on initialization until I hit CTRL-C, which makes it impossibel to have it auto starting.
Trying from start... What needs to be enabled in raspi-config:
P1 Camera Enable/Disable connection to the Raspberry Pi Camera P2 SSH Enable/Disable remote command line access to your Pi using SSH P3 VNC Enable/Disable graphical remote access to your Pi using RealVNC P4 SPI Enable/Disable automatic loading of SPI kernel module P5 I2C Enable/Disable automatic loading of I2C kernel module P6 Serial Enable/Disable shell and kernel messages on the serial connection P7 1-Wire Enable/Disable one-wire interface P8 Remote GPIO Enable/Disable remote access to GPIO pins
Then on to conflocal, what needs to be enabled/disabled:
Camera_Present = False TCA9545_I2CMux_Present = True SunAirPlus_Present = True AS3935_Present = True DS3231_Present = False BMP280_Present = False BME680_Present = True HDC1080_Present = False SHT30_Present = False AM2315_Present = False ADS1015_Present = False ADS1115_Present = True OLED_Present = True OLED_Originally_Present = True WXLink_Present = True Sunlight_Present = True TSL2591_Present = True DustSensor_Present = True
|
|
|
Post by SDL on Jan 20, 2020 6:34:28 GMT -8
The device present variables in conflocal.py are overwritten in memory by the start of SkyWeather.
So that does nothing.
Is this the same as your other post today? Hanging after "after SHT30"?
BP
|
|
|
Post by triggerfish on Jan 24, 2020 9:46:03 GMT -8
The device present variables in conflocal.py are overwritten in memory by the start of SkyWeather. So that does nothing. Is this the same as your other post today? Hanging after "after SHT30"? BP Basically yes. I seem to experience a lot of things failing I will re-attach the AM2315 again as suggested in the other post. See if that helps...
But... The true/fasle sesttings in the conflocal have no actual steering at all? So it does not matter what they are set to, on starting the program, it will figure out what's there and what's not???
|
|
|
Post by SDL on Jan 24, 2020 15:16:30 GMT -8
Correct. They are just establishing the variable.
BP
|
|