chet
New Member
Posts: 48 
Raspberry Pi: Yes
Other Device: PC, ESP8622
|
Post by chet on Apr 6, 2020 13:30:58 GMT -8
Ourweather v2 board is not even going all the way in boot. It only show ourweather then whe it comes to get to the wifi part it just sits there. I even tryied connecting it to my computer and it does not see it. I am running windows 10 pro. Yes all the drivers are installed.
|
|
|
|
Post by SDL on Apr 6, 2020 15:34:35 GMT -8
Make sure your baud rate is set to 115200.
Install the Arduino IDE and try to compile the software for the board.
After you have done this, post your results and we will go to the next step. Do you just have the board or the whole OurWeather kit?
Do you have an AM2315 plugged in? You might remove that if you do. Occasionally we get one that hangs.
BP
|
|
chet
New Member
Posts: 48
Raspberry Pi: Yes
Other Device: PC, ESP8622
|
Post by chet on Apr 7, 2020 4:15:27 GMT -8
I have the new temp\humity hooked to also it use to be detected by my computer but now it does not. So I do not have any ideas what is going on as I am now using ourweather board v1. that seems to be working ok. The broad was an upgrade to replace v1. as I saw it has more options than v1. So what do you recommend. I am not dead in the water as I do have v1. Thank you for being very responsive.
|
|
|
|
Post by SDL on Apr 7, 2020 7:07:21 GMT -8
Chet,
Do the following with the V2 board:
Make sure your baud rate is set to 115200.
Install the Arduino IDE and try to compile the software for the board.
After you have done this, post your results and we will go to the next step. Do you just have the board or the whole OurWeather kit?
BP
|
|
