|
Post by wheald on Apr 11, 2020 16:57:44 GMT -8
I have a question about the wiring in this table that maybe someone else has encountered.
On step 6 of the SolarMAX LiPo Grove Wiring have you using 20cm Grove Connector Marked D8/D9 on the Mini Pro LP (Part I) and have you connect the other end to the WatchDog
On step 9 of the SolarMax LiPo Grove Wiring have you using a 20cm Grove connector Marked D8/D9 on the Mini Pro LP (Part I) and have you connect the other end to the USB PowerCenteral Control/ Enable Grove Connector.
Maybe I'm not seeing this correctly, but both have the same port on Mini Pro LP
Thank you so much any suggestions you may on this.
|
|
|
Post by SDL on Apr 12, 2020 8:49:58 GMT -8
|
|
|
Post by wheald on Apr 12, 2020 9:18:42 GMT -8
Thank You!!! Now I can complete my project.
|
|
|
Post by wheald on Apr 12, 2020 9:43:40 GMT -8
I noticed that step 9 is missing on the new link you sent. Does that mean I don't need a connect to the USB PowerCenteral Control/ Enable Grove Connector? I also noticed in the same link that the picture do not show a 20cm Grove Connect to the USB PowerCenteal.
Thanks
|
|
|
Post by SDL on Apr 13, 2020 16:02:52 GMT -8
No, you should. It's there, but on the next page.
If you don't, then the computer can't shut off the 5V power for low power conditions and turn on when the battery has recovered. Hysterisis. It's still run without it.
BP
|
|
|
Post by wheald on Apr 13, 2020 18:22:58 GMT -8
Got it..And as always thank you!!
|
|