Problem with early SGS Extender Boards! We know what it is!

Folks,

We had an error in our project kit building process that sent some, if not all, of SGS Extender Boards (the ESP32 board) out unprogrammed. Bummer! The few rewards we have not shipped out yet will be shipped with the programmed boards.

We will send out programmed boards out immediately (like tomorrow and this weekend) to all of you backers. Please keep the other board with our compliments. We screwed up!

You can tell if you have an unprogrammed board by watching the LEDs on power up. They will cycle through in a pattern on power up and then the OLED board will NOT turn on.

You can program them yourselves, if you like, but we intended to send new ones all programmed.

If you want to try, check out the code at:

github.com/switchdoclabs/SDL_ESP32_WirelessSmartGardenExtender

And read the tutorial to use the Arduino IDE to program your board. Our board emulates an Adafruit ESP32 Feather, FYI.

learn.adafruit.com/adafruit-huzzah32-esp32-feather/using-with-arduino-ide

Don't worry about it though, you will have another board soon.

This is a picture of the SGS Extender Board below.

Best regards,

Laurie Vessey, President