vb
New Member
Posts: 4
|
Post by vb on Oct 5, 2020 9:08:36 GMT -8
Hi, I'm converting an Arduino project to RPi v4. I use several Arduino Uno v3 GPIO pins, with 5V logic connected to them. I count on the Arduino's pull-up pins for these to work correctly. Do the Pi2Grover 5v GPIO pins have pull-ups? If so, what is the value of the pull-up, and what is the current spec on each GPIO?
Apologies if these questions are answered in documentation somewhere. I didn't find that info online. I just ordered the Pi2Grover and 4ch ADC, and want to be ready to use them when they arrive later this week. Thanks!
|
|
|
Post by SDL on Oct 5, 2020 17:20:09 GMT -8
The pull-ups are 10K ohms. And are 5V. The current specs on the GPIOs are about the same as on the Raspberry Pi GPIOs as there are just level translators between the GPIO pins and the Grove connectors.
BP
|
|
vb
New Member
Posts: 4
|
Post by vb on Oct 8, 2020 9:33:50 GMT -8
Thank you!
|
|