SGS2.py running on SkyWeather ?

frenchie
New Member

Posts: 16

SGS2.py running on SkyWeather ? Nov 30, 2020 5:10:19 GMT -8

Quote

Post by frenchie on Nov 30, 2020 5:10:19 GMT -8

Good morning,

Is it possible to run SGS2.py on the same raspberry pi that SkyWeather.py is running on?

In this situation the SkyWeather2 board is not connected. Is that going to cause issues ?

Many thanks for the pointers.
Colin

SDL Global Moderator Posts: 5,540 Raspberry Pi: Yes Other Device: PC, arduino, beagleBone	SGS2.py running on SkyWeather ? Dec 2, 2020 8:43:22 GMT -8 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by SDL on Dec 2, 2020 8:43:22 GMT -8 Yes, it will cause problems. It should work, but you won't have barometric pressure, although you could probably kludge the software to read the barometric pressure from the SkyWeather barometric pressure sensor. BP

frenchie New Member Posts: 16	SGS2.py running on SkyWeather ? Dec 3, 2020 9:00:37 GMT -8 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by frenchie on Dec 3, 2020 9:00:37 GMT -8 I was just no so keen to have all those Raspberry's out there. Some testing to be performed with piggy-backing Weather Board and weatherboard 2 ?

SDL Global Moderator Posts: 5,540 Raspberry Pi: Yes Other Device: PC, arduino, beagleBone	SGS2.py running on SkyWeather ? Dec 3, 2020 13:11:24 GMT -8 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by SDL on Dec 3, 2020 13:11:24 GMT -8 Not sure what you mean by piggy backing. Plugging the SkyWeather2 board on top of the Pi2Grover should work. Then you will have the barometer. I don't think the barometers are on the same I2C address! John

Post by frenchie on Nov 30, 2020 5:10:19 GMT -8

Post by SDL on Dec 2, 2020 8:43:22 GMT -8

Post by frenchie on Dec 3, 2020 9:00:37 GMT -8

Post by SDL on Dec 3, 2020 13:11:24 GMT -8

Quick Reply