Factory reset SmartGarden Wireless Extender

KevinEleven1 Guest	Factory reset SmartGarden Wireless Extender Dec 30, 2020 6:43:00 GMT -8 Quote Select Post Deselect Post Link to Post Back to Top Post by KevinEleven1 on Dec 30, 2020 6:43:00 GMT -8 Hi, How can you manually reset the Wireless Extender via the buttons on the board? One of the controllers keep rebooting to the Smart Garden logo on the OLED screen and stops there. Thanks in advance.

SDL
Global Moderator

Posts: 5,655
Raspberry Pi: Yes
Other Device: PC, arduino, beagleBone

Factory reset SmartGarden Wireless Extender Dec 31, 2020 6:15:45 GMT -8

Quote

Post by SDL on Dec 31, 2020 6:15:45 GMT -8

Here is how to factory reset the SGS2 Wireless Extender.

1) Power off your board.

2) Hold down the Aux Button

3) Apply power to the board

4) Release the Aux button when you see the SGS Logo appear on the OLED.

Now the board is reset to it's factory default state and you can set it up again.

BP

kevin030 New Member Posts: 2	Factory reset SmartGarden Wireless Extender Dec 31, 2020 8:24:24 GMT -8 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by kevin030 on Dec 31, 2020 8:24:24 GMT -8 Reset worked. Thanks for this. Connection with Wifi is back on track, only the extenders both have a IP of 0.0.0.0 (Green slow blink) but not accessibel

SDL Global Moderator Posts: 5,655 Raspberry Pi: Yes Other Device: PC, arduino, beagleBone	Factory reset SmartGarden Wireless Extender Dec 31, 2020 8:32:05 GMT -8 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by SDL on Dec 31, 2020 8:32:05 GMT -8 Did you set the WiFi SSID and password as per the configuration manual? BP

Post by KevinEleven1 on Dec 30, 2020 6:43:00 GMT -8

Post by SDL on Dec 31, 2020 6:15:45 GMT -8

Post by kevin030 on Dec 31, 2020 8:24:24 GMT -8

Post by SDL on Dec 31, 2020 8:32:05 GMT -8

Quick Reply