|
Post by cciecanuck on Jan 13, 2021 10:40:16 GMT -8
Hi ,
I recently purchased the smart garden system and are in the process of testing the components before putting them into production work. One of the sensors reads nothing but 0 even when put into water, the other 3 sensors are working fine. How do you go about getting this replaced?
Some feedback on SD pre-installed card you sell:
1) Reset the screen resolution to use the monitor default, i thought the image was bad because it would not display on my monitor. The card currently has the display settings hard coded.
2) Your wifi key in the wpa_supplicant file.
|
|
|
Post by SDL on Jan 14, 2021 8:23:19 GMT -8
Thanks for the advice on the card! We changed our WiFi password of course.
I'll look into the monitor issue. We didn't hardcode this on purpose. We'll look Into that.
PM us your address and we will send you a new sensor. Not a problem! Refer to RMA #011421-01
BP
|
|