|
Post by kaiserb on Apr 30, 2021 4:10:01 GMT -8
Just a quick note to say I received my AQI Solar setup yesterday from the KS Campaign. Thank you so much for an easy to use product. It took me less than 30 min start to finish to have an AQI reading on my weather dashboard. I will be casing the unit up next week after I run it a few days on the bench, but overall I could not be happier with the performance and ease of use so far. - Instructions were spot on for initial setup (have not gone through the low power options yet)
- Thanks for the note on polarity and the silk screen on the board (polarity was correct on battery but terminal plug was reversed)
- Initial data pull (used NodeRed to check traffic on 433mhz) was easy to ID and separate.
Looking forward to checking out my AQI data over the long term. Usually we have a lot of "ozone days" in the summer that should give it a real test in the North Texas heat.
|
|
|
Post by SDL on May 1, 2021 17:02:51 GMT -8
That is great news! I love it! We are moving this to the WeatherSense Sensors topic.
BP
|
|