wshealy
Full Member
Posts: 187
Raspberry Pi: Yes
|
Post by wshealy on Feb 26, 2022 10:46:04 GMT -8
Finally getting to assemble my SkyCam. I have gotten down to the wifi provisioning section. I am on a PC. I selected the SkyCam-xxxx from my available networks and copied down xxxx. Normally the join type screen opens in the default browser butt nothing. Do I need to go buy a MAC - nada? How do I open the provisioning window?
Thanks
Wallace
|
|
|
|
Post by SDL on Feb 26, 2022 11:02:49 GMT -8
Depends on your browser and OS. Sometimes they don't force open a window. Make sure you are connected, then open a browser window and type That should open it. BP |
|
wshealy
Full Member
Posts: 187
Raspberry Pi: Yes
|
Post by wshealy on Feb 26, 2022 14:41:26 GMT -8
What should I type?
W
|
|
|
|
Post by SDL on Feb 27, 2022 10:01:44 GMT -8
Ha! The editor wiped it:
http://192.168.4.1
BP
|
|
wshealy
Full Member
Posts: 187
Raspberry Pi: Yes
|
Post by wshealy on Feb 27, 2022 13:08:41 GMT -8
Worked! Now to test.
|
|
wshealy
Full Member
Posts: 187
Raspberry Pi: Yes
|
Post by wshealy on Apr 24, 2022 5:54:48 GMT -8
I need to change the ip address of Sky2 MQTT server on the SkyCam. How do I get back to the config page of an already setup SkyCam? I tried the ip address on my SSID.
W
|
|
|
|
Post by doxidad on Apr 24, 2022 8:51:10 GMT -8
Turn off your router and wait about 5 or so minutes and then power up the SkyCam. You should see the camera show up as an access point and you can make your changes. Once they are done and saved, turn you router back on. After the router is up, you may have to power cycle the SkyCam.
The bottom line is if the camera can't make a connection to your Wifi it goes into access point/setup mode.
|
|
|
|
Post by SDL on Apr 24, 2022 15:50:11 GMT -8
|
|
