When using SG configuration utility to assign a bluetooth sensor, when I try and select the extender for the sensor (I have only one), when I pick it the system erases the button and "enter name" dialog, doesn't assign it, and goes right back to the screen with no assignment made.
Is there something specific i need to do, or can I just edit the JSON file by hand to make the assignment? Either is fine with me, I'd just need the syntax of the JSON entry for the assignment.
The images show just before I click to pick the extender, with a follow on image after I pick the single extender in the system. No change and the SG3 status page show no assignment made when I restart it.
DB: SmartGarden3 Table: BluetoothSensors Column: fullAddress Note: repeat the last four digits in column: pickaddress E.g; ID: *autoassigned* fullAddress: C4:7C::6E:0D:DD pickAddress: 0D:DD assignedWirelessID: Your extenders four-digit address, it will be on the front display of the extender name: whatever you want it to be [Go]
I'll check back in tomorrow to see if it went ok for you.