|
|
Post by riffelrw on Jun 13, 2022 14:29:29 GMT -8
I'm looking at 3D printing a custom enclosure to mount under my deck. Is there a way I can get a board drawing for both the extender and the relay board showing hold dimensions and positions, so I can do the 3D design in Fusion without just measuring with a caliper (which is generally not something I'm good at)...
Also checking to see if there is anything relative to a board spec for the extender?
Thanks
|
|
|
|
Post by SDL on Jun 14, 2022 14:48:26 GMT -8
We don't have those models. I would suggest using a caliper (which we aren't good at that either) and measuring the boards and building the models in Fusion 360.
No board level spec for the extender, although I'm happy to answer questions.
BP
|
|
|
|
Post by riffelrw on Jun 15, 2022 18:48:29 GMT -8
Thanks. On the Mini Pro Plus board there are two Grove connectors labeled TXOut and RXOut. Since the Micro connector is already connected to the Serial.xxxx peripheral, I assume to use these other Grove connectors I need to use a soft-serial implementation. What lines are these connectors wired to, so I have the correct initialization for any SoftwareSerial peripheral. I see in a photograph that they are listed with TXOut D8 and RXOut D9 - but does that mean there is only one connection on each digital line, and the 2nd digital line is not connected?
|
|
|
|
Post by SDL on Jun 16, 2022 18:35:40 GMT -8
Here is the schematic for that part of the board. BP Attachments:
|
|
