Post by Jason on Jul 31, 2022 6:18:42 GMT -8
Looking for suggestions on how to attach the solder tabs in the link below to the Raspberry Pi GPIO header?
Flat flex cable
Thanks,
Jason
Flat flex cable
Thanks,
Jason
- General
- Product Support
- WeatherRack3 - No Moving Parts Weather Station
- RadSense - WeatherSense Radiation Detector
- SmartGarden3
- SkyWeather2 - Wireless Weather Station
- WeatherSense Sensors and Software
- SolarMax2
- WeatherRack2 - WeatherSense Wireless
- SDL SDCard Questions
- Smart Garden System
- SunAirPlus (2 and 3)
- OurWeather
- SkyWeather
- ADC - 4 Channel I2C
- Air Quality Sensor Extender Kit
- AM2315 Temperature / Humidity Sensor
- DS3231 RTC Clock Module
- FTDI 3.3V/5V Cable
- GPIO Grove 8 Bit I2C Extender Board
- GPIO 8 bit I2C Extender Board
- Grove PowerDrive
- Grove PowerSave
- Grove Arduino Base Shield
- GroveWeatherPi
- HDC1080 Temperature / Humidity Sensor Grove
- I2C 4 Channel Mux Board Grove
- INA3221 3 Channel Current / Voltage Sensor Grove
- Laser Dust Sensor - HM3301
- LED Pixel and 8 Stick Support (Compatible with NeoPixels)
- Lightning Detector - MOD-1016G Grove
- Mini Pro LP Arduino Board with Grove
- Moisture Sensor Grove
- Moisture Sensor HR Grove
- MouseAir
- OLED Display
- OurWeather ThunderBoard Lightning Detection Extender Kit
- Pi2Grover
- Quad Power Management Board
- Rotary Dial / Stand Alone Switches
- SolarMAX
- Solar WXLink - Remote Solar Powered Weather Link
- Smart Garden System (retired Version 1)
- SmartPlantPi
- SunAir - Solar Power Controller
- SunControl
- Sunlight SI1145 Grove Sensor
- Thunder Board Lightning Detector
- WXLink - Remote Radio Link
- WXLinkWR Interface Board for WeatherRack
- USB Controlled Submersible Pump
- USB PowerControl
- WatchDog Timer - Dual
- Weather Board
- WeatherPiArduino Weather Board
- WeatherPlus Board
- WeatherRack Weather Sensors
- BC24 Ultimate IOT WiFi Night Light
- BC24 Weather
- BC24 - Big Circle 24 Pixel with ESP32
- Solar Power - General
- Project Help
- RasPiConnect/ArduinoConnect