|
Post by pjd2023 on Feb 9, 2023 14:45:29 GMT -8
When I run SG3Configure.py there is an import of pclogging.py which in turn imports SkyCamera.py
SkyCamera pulls in some packages using the scipy package (specifically griddata )
While I wait for the SD Chip with the package on it I have been working on the install myself. I am down to everything running except where scipy is involved .
I'm using Python 3.7 on RPI running 32 bit Buster.
How did you get the scipy package to work ? My attempts always fail when the numy wheel is being built (even though pip show numy already installed.
If I comment out the import of SkyCamera then SGConfigure "works" but the bluetooth sensors tab ignores any clicks. Is there a way to comment out all references to scipy but have the bluetooth sensors sections of the code still work ?
|
|
Scipy solved but hotspot setup
Guest
|
Post by Scipy solved but hotspot setup on Feb 9, 2023 17:40:14 GMT -8
Figured it out how to install scipy
but…. I still can’t get the scan for Bluetooth sensors to see the moisture sensors.
in the blog you have a method for scanning in Bluetooth that requires using the networkmanger to setup a hotspot. But, this only works in the bullseye release. And I’ve only been able to get the system to work in buster. Do u have a method for setting up a wifi hotspot in buster?
|
|
|
Post by SDL on Feb 16, 2023 9:23:05 GMT -8
|
|