|
Post by swampdonkey on Jun 21, 2017 7:07:57 GMT -8
I have a weather plus board that I connected to a wireless Lan, but I now want to change this to another network. While I have turned off the unit (for over a week) it still picks up the original network. How can I set it to provide the weather board access point again so I can redefine the wifi network
|
|
|
Post by SDL on Jun 21, 2017 9:48:53 GMT -8
Look in the advanced manual for the way to clear out your memory and the WiFi settings. I think (and I am doing this from memory since I am not in the office) you hold GPIO0 button down during the entire boot up process.
BP
|
|