|
Post by Lee2 on Apr 20, 2018 18:49:15 GMT -8
Apparently the Sunlight sensor is defective. I get 0.0 no matter how much light is hitting it.
|
|
|
Post by SDL on Apr 23, 2018 12:56:37 GMT -8
Awesome about the Window! I will start using that too.
Regarding the Thunderboard, yes, only if you receive an interrupt. Get a big noise source near it and it should at least report noise.
We sell a Thunder Simulator to make this testing easier (and a lot cheaper than the AMS unit).
BP
|
|
|
Post by SDL on Apr 23, 2018 12:57:50 GMT -8
Lee2,
Here is the RMA for the Sunlight Board. It appears to be not reading the sunlight.
SwitchDoc Labs RMA#042318-01 909 S Shelley Lake Lane Spokane Valley, WA 99037
BP
|
|
lee
New Member
Posts: 36
|
Post by lee on Apr 23, 2018 14:51:24 GMT -8
Thanks for the RMA, but in the interest of gettig this going, I already ordered a replacement. It also gave e the opportunity to order the OurWeather AirQuality Extender Kit, which in the other post said I could easily add to my system. Looking forward to further info!
I'll let you know how this sunlight sensor works out.
|
|
|
Post by Lee2 on May 3, 2018 19:56:38 GMT -8
Ok.. Replaement Sunlight sensor installed, still getting the Error 121, awaiting the fix.
Also, eager to get the air quality sampling setup going.
|
|
|
Post by Lee2 on May 3, 2018 19:59:06 GMT -8
ugh. now that the loop has been running for a while, the sunlight senor error 121 magically goes away, replaced by actal data! too bad its all zero! another defective board?
|
|
|
Post by Lee2 on May 4, 2018 10:27:14 GMT -8
Sometimes I get the 0.0 from the sunlight sensor, mostly I get the error 121. It's sporadic..
|
|
|
Post by SDL on May 5, 2018 14:54:54 GMT -8
Lee(s),
I haven't seen your RMA. Did you send it back in?
Have you run the new sensor with demo.py?
BP
|
|
|
Post by Lee2 on May 5, 2018 16:35:01 GMT -8
No, I threw it away, and just ordered a new one, alo9ng with the air quality kit. Here's my original post
"Thanks for the RMA, but in the interest of gettig this going, I already ordered a replacement. It also gave e the opportunity to order the OurWeather AirQuality Extender Kit, which in the other post said I could easily add to my system. Looking forward to further info!
I'll let you know how this sunlight sensor works out."
|
|
|
Post by SDL on May 7, 2018 12:19:20 GMT -8
Have you run the new sensor with demo.py?
BP
|
|
lee
New Member
Posts: 36
|
Post by lee on May 7, 2018 17:38:29 GMT -8
I have not. I will have to disconnect everything again and just plug it in and try it.
But I'll let you know the results!
Thanks
|
|