ys96
New Member
Posts: 1
|
Post by ys96 on Jul 9, 2018 3:08:49 GMT -8
Hi,
I had a few questions regarding this anemometer alongside the Weatherboard that is needed with it. My first question is how much voltage is required to power anemometer, I understand it is 3.3V for just the board, but the actual part I can’t find. As a follow up, is it possible to control the board via an FPGA? I see that the board is I2C compatible, but for Arduinos and rasp PI’s.
Thank You
|
|
|
Post by SDL on Jul 10, 2018 6:27:48 GMT -8
ys96,
3.3V is used for the anemometer (through a pulp) too.
Sure, you could control the board with an FPGA. A bit tricky implanting the entire I2C interface, but the interrupts and ADC for the WeatherRack should be straight forward.
BP
|
|