Hello...my suggestion would be to make sure the information you are using is relevant to the revision of control board you have. Its folly to quote settings without knowing exactly which board is in your unit,there should be a little tag with harman's part number on it.
Post by Powderjockey on Oct 12, 2020 8:31:40 GMT -8
I unplugged the BC24 from the laptop to move to another computer and when I plugged it in to the other computer, I get nothing. No lights.I've pressed the reset and mode buttons at the same time and individually and still nothing. Appears to be dead.
Edit: The Blink sketch works and Arduino IDE sees the device. I can upload any of the BC24 sketches with no problems. Just no lights.