Brakow's Grove Weather Pi Build

Can't take all the credit for this.  3d printed parts can be found below:
Board Holders and solar prints created by TexAg - Solar Panel Bracket and Component Clips for GroveWeatherPi
Case and Window for Solar/UV Sensor by leemaisel - GroveWeatherPi Sunlight Sensor WINDOW FRAME


Started with an old telephone communications box I had laying around for a few years.  Created a 3d printed screen so to speak, to keep any condensation off of the electronic components.


Next I printed board holders and mounted them.  


I then mounted the Sunlight/UV Sensor and installed the special UV glass piece from SwitchDoc here 


Next the Temp/Humidity sensor was mounted under the shield.


Then, I wired the solar system and all panels





I then wired the entire system and mounted outside, powered on, and good to go!