|
Post by SDL on Feb 6, 2019 18:16:43 GMT -8
|
|
|
Post by agronaught on Mar 26, 2019 5:17:18 GMT -8
I can confirm the same issue outlined in this thread.
I just received the WxLink kit and had no data being transferred when it was all plugged in. Further investigation found the same 'no init' issue on both the TX and RX boards, rebuilding the software (github) with the library from seed studio corrected the behaviour.
After this I have the data being sent and received by the OurWeatherPlus board. Reception is a little dodgy with only ~50% of packets being decoded, but that could simply be a noise issue in my office while testing. I'll wait until the system is in place before looking further into that.
Cheers J.
|
|
|
Post by SDL on Mar 28, 2019 6:32:18 GMT -8
Argonaught,
We have a little more information on that. I think the error rate will go down a great deal if we reduce the transmit power. We hope to prove this on Friday or even this weekend.
BP
|
|
|
Post by agronaught on Mar 29, 2019 7:32:08 GMT -8
Yes - attenuating the signal by placing the antenna in it's sub-optimal final position also worked. No to mention the noise from the LED lighting in my office here wasn't helping with the decodes.
All good on the signal front, nothing I can't remedy from careful placement of the modules.
|
|
|
Post by SDL on Mar 30, 2019 13:04:51 GMT -8
|
|