hsolo
New Member
Posts: 9
|
Post by hsolo on Jan 17, 2019 16:36:18 GMT -8
Hey SDL, My SGS is up and running with the 4 plant extender board.
detecti2c -y 1 and testAllSensors.py show what it should according to the manual.
I did have to go back and redo the config.py confllocal.py after inputting the auth token for blynk to input both the token and change the plant count to 5 as it had reset the count to one.
But my dashboard is only showing one plant..... Do I have to add more plants somehow in the app?
Thanks HS
|
|
hsolo
New Member
Posts: 9
|
Post by hsolo on Jan 17, 2019 19:46:42 GMT -8
Still trying to figure things out....had the classic flat forehead moment...then I pressed play on the app. But still no luck, I’m getting the message in the app that SGS is offline. I’ve rebooted, rerun the tests, checked the conflocal file to see if anything has changed or was a typo....all good. But still not connecting with the app. Also upon restarting SGS.py only pump #1 ran then stopped. As opposed to all of the pumps. Any ideas?
HS
|
|
|
Post by SDL on Jan 18, 2019 9:31:19 GMT -8
Would you post the startup sequence on the Pi from SGS.py? That will give me a good base line to what is going on.
BP
|
|
hsolo
New Member
Posts: 9
|
Post by hsolo on Jan 18, 2019 11:40:45 GMT -8
Hi BP, Thanks for the reply. Unfortunately I will be on the road until the 27th. I’ll get the start up sequence posted until I get back. I unhooked everything and arranged a sitter for my garden while I was gone 😉. HS
|
|
|
Post by SDL on Jan 18, 2019 14:11:41 GMT -8
You bet! Looking forward to the information. We will get you sorted out.
BP
|
|