|
Post by knichols on Mar 27, 2019 9:22:46 GMT -8
I hope someone can answer this;
I bought the thunder board with grove connectors. The bad news is I don't have a grove board to connect to. What GPIO pins would I have to connect to on the thunderboard to get every to work correctly? The help is much appreciated.
Kevin
|
|
|
Post by SDL on Mar 28, 2019 6:51:14 GMT -8
Kevin, Take a look at the ThunderBoard specification to figure this out. www.switchdoc.com/wp-content/uploads/2018/05/SDLThunderBoard051718.pdfIn summary, you connect the I2C interface up to the GPIO pins (using 3.3V!!!!! - if you use 5V from the GPIO pins you can damage your Pi). Then you look a the software you are using and connect up the Interrupt GPIO to the other connector. BP
|
|