|
Post by treii28 on Apr 9, 2019 17:10:41 GMT -8
[edited]
How do you connect the reset wire on the dual watchdog to on the newer version of the USB PowerControl so it will properly trigger (turn-off-power) the low-power cycle (eventually turning power back on when the batteries recharge?).
According to the articles and diagrams you are supposed to connect the DOG1_ARDUINORESET to Cout (TP3) on the USB PowerControl and I can't find TP3 / Cout.
|
|
|
Post by SDL on Apr 10, 2019 6:47:01 GMT -8
If you look at the pin locations diagram in the USB PowerControl specification, you will see the TP3 test pad marked. This is the COut / TP3 signal mentioned in the specification. It is also clearly marked on the board itself. Since it is in an image, a keyword search will not find it. That is the signal you connect to the DOG1_ARDUINORESET (poorly named) signal on the WatchDog board. BP Attachments:
|
|