|
Post by PM on Apr 28, 2019 20:58:07 GMT -8
Hi,
I have 4 BMP280 connected to the Pi2Grover board. I only see one of them:
sudo i2cdetect -y 1 0 1 2 3 4 5 6 7 8 9 a b c d e f 00: -- -- -- -- -- -- -- -- -- -- -- -- -- 10: -- -- -- -- -- -- -- -- -- -- -- -- 1c -- -- -- 20: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 30: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 40: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 60: -- -- -- -- -- -- -- -- -- -- 6a -- -- -- -- -- 70: -- -- -- -- -- -- -- 77
I understand that I need to add something like this :
dtoverlay=i2c-gpio,bus=3,i2c_gpio_delay_us=2,i2c_gpio_sda=23,i2c_gpio_scl=24
to "/boot/config.txt" file. But this one doesn't work. Can you tell me where are all the i2c ports connected to? Which GPIO? Is it the same GPIO? Then how should I configure it to see all four of them?
Thanks -- PM
|
|
|
Post by SDL on Apr 29, 2019 8:24:10 GMT -8
|
|