|
Post by albi90 on Jun 15, 2019 20:09:29 GMT -8
Hi,
I have a Weatherboard with grove connectors that im connecting to a Seeeduino with LoraWan but im not getting any wind speed over the digital grove connector, I can see wind direction so analog is working, the Anemom grove connector is connect to D2 so I have configured the Arduino sketch to use pin 2 with interrupt pin 2 (SAMD21 chip should have the same interrupt pin as the digital pin I believe) any ideas where im going wrong?
|
|
|
Post by SDL on Jun 17, 2019 8:21:28 GMT -8
Make sure you have the anemometer in the right RJ11 connector. Are you getting any rain information or wind direction information?
Put an volt meter on the Anemometer line and see if it changes as you rotote the anemometer.
BP
|
|
|
Post by albi90 on Jun 18, 2019 23:50:11 GMT -8
Firstly thanks for the reply, I’m getting wind direction so we are definitely in the right port, I’ll run some more tests using a volt meter and report back, I’ve also tried using an arduino mega with the same results so I have a feeling it might be a hw issue.
|
|
|
Post by SDL on Jun 20, 2019 8:11:35 GMT -8
Check and make sure the anemometer is plugged in on the Weather Rack too!
BP
|
|