hawk
New Member
Posts: 6
Raspberry Pi: Yes
Other Device: Atomic Pi
|
Post by hawk on Feb 16, 2019 18:33:42 GMT -8
I have been attempting to connect my weather station kit for a few days now and must say that this is the most difficult project I have encountered. I have found different tutorials on Switch Doc for the weather kits, but none of them include using the weather plus board that was included in both of the kits I purchased from Switch Doc Labs. Could someone please tell me where I can find a tutorial for putting these kits together. Every tutorial I found uses the Grove Weather Board, and uses wiring connections that do not exist. It would also be nice if the tutorials actually use photos of the current boards. Any help in obtaining the necessary information will be greatly appreciated. I would like to be able to start testing the sensors within the next 7-10 days if I can get the system wired up correctly.
|
|
|
Post by SDL on Feb 17, 2019 7:38:18 GMT -8
|
|
hawk
New Member
Posts: 6
Raspberry Pi: Yes
Other Device: Atomic Pi
|
Post by hawk on Feb 19, 2019 18:22:34 GMT -8
BP,
I thank you so much for pointing me in the right direction. When I followed you information and went to shop.switchdoc.com/products/ourweather-complete-weather-kit, there in plain sight under downloads is the assembly and operations manual with pretty color pictures and instructions. Had I asked a couple years ago, I could have already had a few years of data. Oh well.... Thanks again
|
|
|
Post by SDL on Feb 20, 2019 18:47:25 GMT -8
Hawk,
You made me laugh! Go get your data now!
BP
|
|