Post by intihuatana on Apr 29, 2020 10:28:55 GMT -8
hello @all,
my USB out from the SunControl Board delivered the days only ~ 2 Volt. After a short push on this black box (marked orange) - Transformer? - it was ~ 5 Volts again and the Pi Zero booted.
In case of low voltage the camera beeped although the Pi Zero had no LED activity.
The board was installed at that time - so it is possible that the pressure moved the whole board or was this a coincidence? By switch off/on I did not get the 5 volts.
The board is now removed and the error is currently not reproducible. What can I test before the board is removed?
In case of low voltage the camera beeped although the Pi Zero had no LED activity.
The board was installed at that time - so it is possible that the pressure moved the whole board or was this a coincidence? By switch off/on I did not get the 5 volts.
The board is now removed and the error is currently not reproducible. What can I test before the board is removed?
best regards
Joe
