|
Post by riffelrw on Jan 31, 2021 9:17:13 GMT -8
Trying to get Blynk setup with Skyweather2. Set up the new panel in blynk using a previous installation and enabled configuration, but wasn't getting any data. It could be a blynk config issue, i'm new to it and not fully understanding. I enabled the SW debug in the blynk python script and captured the output to a fule debug (2.85 KB). I can't tell if these are true errors and i'm configured wrong on Blynk or if it's on the Pi 4. Also noted that on the blynk app, it has a SkyWeather device (from prior installation) and I created a new one called skyweather2 using a RPi 3B (ethernet) b/c I didn't see a Pi 4 selection. Any ideas? I could just be a hot mess on the blynk side but followed the configuration pdf.
|
|
|
Post by SDL on Feb 2, 2021 16:13:07 GMT -8
The computer setting in Blynk doesn't matter. They don't update that part of the app for some reason. I just looked at your debug file and you are using V017. Head over to this forum page and get the latest version. I see an error that is fixed. forum.switchdoc.com/thread/1452/skyweather2-software-releasesBP
|
|
|
Post by riffelrw on Feb 3, 2021 11:53:14 GMT -8
That fixed it - appreciate it!
|
|