wshealy
Full Member
Posts: 187
Raspberry Pi: Yes
|
Post by wshealy on Apr 29, 2021 17:52:56 GMT -8
 Is this right usb connector around antenna? Also what pin is AQI power control? W
|
|
|
|
Post by doxidad on Apr 30, 2021 2:33:44 GMT -8
Be careful with that antenna. There is not much room between the USB A and antenna. Mine broke the solder joint since it was only soldered on the top pad and not all the way though. I couldn't figure out why I was loosing the radio connection until I found it loose. It's not like I was being a gorilla putting things together either. I suppose board placement could have been a bit better so there wouldn't be this interference.
Instead re-soldering it, I just replaced the antenna with an external.
|
|
|
|
Post by SDL on May 1, 2021 17:06:56 GMT -8
The USB connector is plastic, so no problem. Take a look at the low power option section in the manual. It's shown there.
Doxidad,
Yes, next rev of that board and/or box, we are moving it. Too tight.
BP
|
|
Is this right usb connector around antenna? Also what pin is AQI power control?
