|
|
Post by Jason on May 11, 2021 5:02:19 GMT -8
I'm trying to mount my Mini Pro Plus to the box. The documentation recommends 5mm M3 screws. I can't get my M3 screws through the holes in the board. Has anyone else had a similar experience? If so, any workarounds to suggest?
Thanks,
Jason
|
|
|
|
Post by doxidad on May 11, 2021 5:45:10 GMT -8
I used a small round needle file.
|
|
|
|
Post by Jason on May 11, 2021 6:58:14 GMT -8
I used a small round needle file. That I can do! Thanks! Jason |
|
|
|
Post by SDL on May 11, 2021 8:05:26 GMT -8
Hmm. I'm thinking these 3MM screws vary a little. I have just driven the 3MM screws into the board (like they were self threading) with little problem.
I am using a full hex screwdriver, so I have good torque.
BP
|
|
|
|
Post by Jason on May 13, 2021 9:16:45 GMT -8
A 1/8” drill bit did the trick!
Jason
|
|
