Post by ja2 on Dec 20, 2017 7:20:50 GMT -8
We are trying to connect Dual WatchDog Timer Board with a Beaglebone Black.
We're newbies in IoT world and we have some questions and doubts about hardware and software.
Is this connection schema correct?
BBB P9_5 (VDD_5V) -> SDL VDD
BBB P9_1 (GND) -> SDL GND
BBB P8_14 (GPIO) -> SDL JP7 Dog1 Input
BBB P9_10 (SYS_RESETN) -> SDL JP4 Arduino Reset
Is enough, or is needed to connect Pin 1 and Pin 2 of GROVE connector to 3.3 V like says in forum.switchdoc.com/thread/283/documentation-model-connection-watch-dog ?
Do you have any test code for Beaglebone like code we found in forum.switchdoc.com/thread/283/documentation-model-connection-watch-dog?
In this code what is the meanig of RESET_WATCHDOG1 = 12 and READ_WATCHDOG = 6 or what are their equivalent for Beaglebone Black code?
Thanks in advanced.
We're newbies in IoT world and we have some questions and doubts about hardware and software.
Is this connection schema correct?
BBB P9_5 (VDD_5V) -> SDL VDD
BBB P9_1 (GND) -> SDL GND
BBB P8_14 (GPIO) -> SDL JP7 Dog1 Input
BBB P9_10 (SYS_RESETN) -> SDL JP4 Arduino Reset
Is enough, or is needed to connect Pin 1 and Pin 2 of GROVE connector to 3.3 V like says in forum.switchdoc.com/thread/283/documentation-model-connection-watch-dog ?
Do you have any test code for Beaglebone like code we found in forum.switchdoc.com/thread/283/documentation-model-connection-watch-dog?
In this code what is the meanig of RESET_WATCHDOG1 = 12 and READ_WATCHDOG = 6 or what are their equivalent for Beaglebone Black code?
Thanks in advanced.
