|
Post by charliee on May 16, 2018 2:50:05 GMT -8
When I have my 4 jumper pins from JP7 to JP6 I cannot physically use a Grove cable in J5, which should be Bus 3. Can I use the pins on JP4 instead?
Never noticed this before. Even the I2CMux Grove Board Pinout document shows this interference. Or am I missing something here. I am also curious as to the naming of the "pins vs plugs", ie the seeming inconsistancy of linking J4 with JP5 and J5 with JP4. Thanks much. CharlieE
|
|
|
Post by SDL on May 17, 2018 9:53:28 GMT -8
Charliee,
We are revising this board as we prepare for the next production run. We are fixing that.
The easy fix is to use a pair of wire clippers and cut off the buckle on the Grove cable. Then it will fit.
"J" refers to a Plug (such as a grove plug), "JP" refers to a pin header.
Best regards,
BP
|
|