|
Post by buckwestern on Nov 19, 2018 10:20:17 GMT -8
now it is charged:
SunAirPlus Currents / Voltage ----------------- LIPO_Battery Bus Voltage: 4.10 V LIPO_Battery Shunt Voltage: 0.00 mV LIPO_Battery Load Voltage: 4.10 V LIPO_Battery Current 1: 0.00 mA Battery Power 1: 0.00 W
Solar Cell Bus Voltage 2: 0.39 V Solar Cell Shunt Voltage 2: 0.00 mV Solar Cell Load Voltage 2: 0.39 V Solar Cell Current 2: -0.00 mA Solar Cell Power 2: -0.00 W
Output Bus Voltage 3: 5.11 V Output Shunt Voltage 3: 0.44 mV Output Load Voltage 3: 5.11 V Output Current 3: 4.40 mA Output Power 3: 0.02 W
|
|
|
Post by SDL on Nov 21, 2018 8:57:45 GMT -8
Two different controller chips. I think SunAirPlus (which has an older chip) is stopping charging at 4.10 or so, while Sun Control keeps going until I would guess 4.14 or 4.17V.
BP
|
|
|
Post by buckwestern on Nov 21, 2018 9:47:23 GMT -8
well, the last post was with the SunControl board.
so what is the verdict?
|
|
|
Post by SDL on Nov 22, 2018 8:08:02 GMT -8
Buckwestern,
The two boards just charge to different 'full" levels. All seems good.
BP
|
|